Topic Options
#18038 - 06/22/04 11:51 AM Gridline Pain
Crystal Offline
Junior Member

Registered: 06/22/04
Posts: 18
I use the gridlines quite a bit to set up documents... I'm noticing that they are touchy to remove - and I frequently find that instead of removing the one I intended to remove, I have in fact just created a new one!?

Also, often the blue arrow isn't in alignment with the gridline on the page which it is suppose to be aligned with (which is confusing!)

Finally, when I set up on an 11x17 in landscape mode - the gridline doesn't stretch the entire width of the page??

Top
#18039 - 06/22/04 06:59 PM Re: Gridline Pain
Anonymous
Unregistered


Hello,

I will pass your comments to our Product manager and R&D team.

Point 3 is a known bug in the software.

Top
#18040 - 06/23/04 08:57 AM Re: Gridline Pain
Crystal Offline
Junior Member

Registered: 06/22/04
Posts: 18
Alright, thank you.

Top
#18041 - 06/23/04 09:00 AM Re: Gridline Pain
Anonymous
Unregistered


Hello,

I looked over the points that you mentioned above again and I am wondering what version of PlanetPress 4 are you using?

I dropped guidelines on my page and then dropped a box to see if the line was lined up with the blue arrow and they always are.

Top
#18042 - 06/23/04 10:28 AM Re: Gridline Pain
Crystal Offline
Junior Member

Registered: 06/22/04
Posts: 18
I am using Version 4.0.33.1463... actually I just updated yesterday, and haven't worked with PlanetPress since.

I just checked it myself, and admittedly I can't get it to repeat now either. I'll let you know if that changes.

Top
#18043 - 06/23/04 03:46 PM Re: Gridline Pain
Crystal Offline
Junior Member

Registered: 06/22/04
Posts: 18
I was just working on another PlanetPress Document and had it happen again where the gridline didn't line up with the blue arrow. Unfortunately, when I close and reopen the document the gridline and arrow were lined up again - so I can't send the file to show you...

I can say that it happened shortly after I readjusted the gridline by double clicking on it and entering the value in the dialog box.

Top