Impose 2up unique Collate cut set up in Design - Objectif Lune Tech Support Self Help

IMPORTANT ANNOUNCEMENT

These forums were permanently set to read-only mode on July 20, 2022. From that day onwards, no new posting or comment is allowed on the site, but the historical content remains intact and searchable.

A new location for posting questions about PlanetPress Suite is now available:

OL Learn - PlanetPress Classic (opens in new tab)

You are not logged in. [Log In] Objectif Lune » Forums » PlanetPress Suite 7 » PlanetPress Design » Impose 2up unique Collate cut set up in Design

Topic Options

#57419 - 02/12/20 07:50 AM Impose 2up unique Collate cut set up in Design
SendStephen OL Newbie Registered: 10/16/12 Posts: 26	Hi, Is it possible to set up the designer so I can impose my document (in this example printing A4 2 up onto A3 unique Collate cut, Duplex) rather than doing at the fiery level- like you can do in printshop mail without going through the fiery rip? Cheers Stephen
Top

#57421 - 02/12/20 11:52 AM Re: Impose 2up unique Collate cut set up in Design [Re: SendStephen]
jim3108 OL Expert Registered: 04/19/10 Posts: 316 Loc: London, UK	You can implement N-Up printing using the N-Up Object in PlanetPress Design. Place your N page on a virtual page (set in properties of page) and then create a normal page for your output. Place the N-Up Object on to that page and select the X and Y N's the virtual page that you can now select in the dropdown on this object.
Top

Previous Topic

Index

Next Topic

Hop to:

Moderator: Alex Banahene, cosimo, Jean-Cédric, OL Newsgroup QA, OL Newsgroup Support, OL Newsgroup Training, Philippe F., Raphael Lalonde Lefebvre